Pullstart MVT ignition Puch Maxi E50 pedal start engine

Pull starter for Puch Maxi E50 engine.

• Ready-to-install pull starter for clockwise rotating Puch E50 engines on your Puch Maxi S / N or Puch Supermaxi LG1 moped. Can only be fitted in conjunction with an MVT ignition system.
  
• Top quality, can be used without problems with all cylinders from 50cc to 74cc!

Mounting:

• Starter pinion: Clean MVT pole wheel, then screw the counterpart for the pull starter onto the pole wheel (secure enclosed screws with Loctite).
  
• Pull starter: Place the starter housing in the correct position and tap lightly with a plastic hammer until the pull starter fits perfectly. It can then be screwed into place. 

Application:

• Before starting, pull the cable slowly a few times so that the engine spins empty (must be done before each start attempt).
  
• Pull out the pull-start handle until it is fully engaged and you encounter resistance. Then pull through in one go.
• Tip: Wear gloves! Hold the handle firmly.

Tipp:

• The pedal system can no longer be operated because the pedal arms would touch the housing of the pullstarter. Therefore, footrests, a longer pedal axle or a pedal axle extension must be fitted.